Flaming River Nova Front Steer Power Rack and Pinion Cradle Kits 1962-67 - Manual (Page 6)

Page 5 of 11
012710
JJ/RD/RP/BC
Original Steering System Removal Con’t
14) Remove the two bolts that retain the factory front spindle arms to the spindle and remove the arms.
Installation of Flaming River Column
1) Slide the floor mount that is included in the kit over the column tube and then slide the original floor seal and floor
plate over the column tube.
2) Slide the column through the firewall so that the end of the column tube is about a ¼” past the firewall.
3) Using the original under dash mount, mount the column to the dash. Only snug the mounting bolts.
4) Set the turn signal arm at the 9 o’clock position; tighten down the mounting bolts to secure the column.
5) Fasten the original floor seal to the firewall using the bolts removed earlier.
6) Next slide the column mounting bracket so that the mounting flange is flush against the floor seal plate, and then
snug the column mounting bracket to the column tube.
7) Fasten the column bracket to the floor seal using the hardware provided. NOTE: The new floor mount assembly
can be removed and painted.