Flaming River Neutral Safety Switch - Manual

800 Poertner Drive
Berea, OH 44017
1-800-648-8022
www.flamingriver.com
Note: For this switch to work correctly the shift linkage must be properly adjusted to the detents in the transmission.
Adjustment:
1) Remove neutral safety switch from column by removing the two retaining screws.
2) While holding the back of the neutral safety switch towards you, align the slotted tab with the first hole
from the left. This is the neutral position in the switch. Place a pin (straightened paper clip) in the hole to
retain this position. (See figure A)
3) Place the gearshift indicator in the neutral position.
4) Place the neutral safety switch onto the column and attach the switch with the screws that were
removed in step one. Snug the screws against the housing.
5) Reattach the wiring ensuring that the neutral safety wires are on the two flat terminals and the reverse
lights are the two offset terminals. (See figure B)
6) Move the gear shifter through the range of gears. The engine should only start in neutral and park.
Fig. A Fig. B
Warranty Disclaimer
Because of their intended usage, the manufacturer makes no warranties whatsoever expressed or implied,
oral or written, to purchasers of their products regarding performance, safety, fit, merchantability or length of
service. Purchasers are responsible for selection of proper goods and must rely on their own skill or
judgment that such goods are suitable for the purchaser’s application.
INSTALLATION BULLETIN # 2011
DESCRIPTION: INSTALLATION AND ADJUSTMENT OF NEUTRAL SAFETY SWITCH.
WARRANTY: ONE (1) YEAR FROM DATE OF PURCHASE. REPLACEMENT OF PRODUCT DEEMED DEFECTIVE BY THE
FACTORY. LABOR NOT INCLUDED.