Anthem AVM 20 v2 - Manual (Page 50)

43
Example 1: Select a Source for the ZONE2 Timer:
• Enter the Setup (section 7.1). Go to ‘1. SET TIME/TIMERS’ and press SELECT.
• Press the button until you reach ‘f. SET ZONE2 TIMERS’.
• Press SELECT. The ‘1f. SET ZONE2 TIMERS’ submenu will appear.
• Press the button until you reach ‘e. SELECT SOURCE’.
• Use the buttons to change to desired Source.
• Press BACK to leave this submenu and return to the SET TIME/TIMERS menu.
If you selected ‘Last Stn’ as your Timer turn-on Source, you can leave it set to the last station you were
listening to, or choose one of your preset stations. To have the Timer turn on to a Preset Station, do the
following from the ‘e. SELECT SOURCE’ menu line (above):
• Use the buttons to change to ‘Last Stn’.
• Press SELECT to highlight ‘Last Stn’.
• Use the buttons to change to the desired FM • AM Preset. These will scroll from ‘AM 1-1’ to
‘AM 1-6’ to ‘FM1-1’ through to ‘FM3-6’ and back to ‘Last Stn’.
• Press BACK to leave this submenu.
Note: The Timer submenu setup procedure is the same for MAIN, ZONE2, and ZONE3.
Example 2: Change ZONE2, TIMER2 to come on Weekdays at 7:35 AM.
• Enter the Setup (section 7.1). Go to ‘1. SET TIME/TIMERS’ and press SELECT.
• Press the button until you reach ‘f. SET ZONE2 TIMERS’.
• Press SELECT. The ‘1f. SET ZONE2 TIMERS’ submenu will appear.
• Press the button to reach ‘TIMER 2: Off’.
• Use the buttons to change to ‘Week’.
• Press the button until you reach ‘a. T2 WEEKDAY ON: 8:00 AM’.
• Press SELECT. The hour is now in red, use the Master Control Knob or the buttons to set the
hour to ‘7’ AM. (Continuing through ‘12’ will advance the AM/PM settings.)
• Press the button. ‘00’ minutes will be highlighted.
• Use the Master Control Knob or the buttons to set the minutes to ‘35’.
• Press BACK to leave this submenu and return to SET TIME/TIMERS menu.
Note: When scrolling between ‘11 PM’ and ‘12 AM’ settings, the display shows ‘--:--’. Timers set in the
‘--:--’ position will be skipped. Thus, to set the Timer to only turn on, set the Off time to ‘--:--’. To
set the Timer to only turn off, set the On time to ‘--:--’.
7. SETUP MENU
continued …