Allied Telesis AT-2872SX - Manual (Page 53)

AT-2872SX ExpressCard Fast Ethernet Fiber Module Installation and User’s Guide
53
3. Install the newly built package which includes the driver and man
page:
rpm -ivh RPMS/i386/bnx2- version .arch.rpm
If you are installing over an existing distribution that may already
contain an older version of the driver, the --force option is needed.
Depending on the kernel, the driver is installed to one of the following
paths:
2.4.x kernels
/lib/modules/kernel_version/kernel/drivers/net/
bnx2.o
2.6.x kernels
/lib/modules/kernel_version/kernel/drivers/net/
bnx2.ko
For the bnx2i driver, the driver is installed on one of the following paths:
– 2.6.16 kernels and newer (bnx2 driver)
/lib/modules/kernel_version/kernel/drivers/
net/bnx2.ko
/lib/modules/kernel_version/kernel/drivers/
net/cnic.ko
– 2.6.16 kernels and newer (bnx2i driver)
/lib/modules/kernel_version/kernel/drivers/
iscsi/bnx2i.ko
4. To load the driver, enter the following:
insmod bnx2
or
modprobe bnx2
5. To load the cnic driver (if applicable), enter the following:
insmod cnic.ko
or
modprobe cnic
To configure the network protocol and address, refer to the documentation