ADTRAN Gigabit Ethernet Single-Mode Fiber Tributary Module 1184518L1 - Manual

DESCRIPTION
The Single-Mode Gigabit Ethernet (GigE) Small Form-
Factor Pluggable (SFP) plugs into ADTRAN GigE modules
designed to accept SFPs. The SFP provides an optical
interface to the GigE physical interface. Installed into an
appropriate host module, the SFP provides a GigE
tributary interface to the supporting system.
NOTE: To ensure compatibility, refer to the documentation
provided with the host module.
♦ 1000Base-ZX: 1550 nm, single-mode, 2 fiber
operation
♦ Maximum optical distance: 80 km
CAUTION: Due to compliance certification requirements,
only SFPs supplied by ADTRAN are to be used
with ADTRAN modules. ADTRAN cannot certify
system integrity with other SFPs.
Operational Specifications
♦ Optical Specifications:
– Optical transmit level: +5 dBm to 0 dBm
– Optical receive level: –3 dBm to –23 dBm
– Optical budget: 22 dB
– Optical connectors: LC
♦ Extended Environmental Support:
– Operational Temperature Range: –20°C to +85°C
– Storage Temperature Range: –40°C to +85°C
– Relative Humidity: 95%, noncondensing
CAUTION: The transmission distance is indicative only. An
in-line optical attenuator should be inserted
between the fiber-optic cable plant and the
receiving port on the transceiver, according to the
following guidelines:
• Fiber span of 0 – 25 km: 10 dB attenuator
• Fiber span of 25 – 50 km:5 dB attenuator
• Fiber span of 50 – 80 km:no attenuator
INSTALLATION
To install the SFP into an appropriate module, complete
the following steps:
1. Inspect the SFP. If damaged, file a claim with the
carrier and then contact ADTRAN Customer Support.
2. Remove the safety cap from the optical connectors of
the SFP.
3. Insert the SFP into the receptacle on the circuit
board of the host module, with the manufacturer’s
label facing outward. Slide the SFP all the way into
the receptacle.
4. Use thumb and forefinger to squeeze the receptacle
and SFP together, to ensure a proper connection.
NOTE: The latch on the SFP is for removal only.
5. Continue the installation and turn-up of the host
module using the instructions in the Job Aid
provided with that module, or using the Installation
and Maintenance Practice (I&M), available online at
www.adtran.com .
PROVISIONING
The SFP is not directly provisionable. To provision the
SFP, access the menu system of the host module. For
more information, refer to the Job Aid or I&M of the host
module for provisioning details.
CLEI: SOOTAHCJ_ _
Product P/N: 1184562PG5 Issue Date: 0804
Document P/N: 61184562PG5-22A
Small Form-Factor Pluggable
Single-Mode Gigabit Ethernet, 80 km