Telenav for Nextel Supported Devices: v3.0 for Motorola i860 - Manual (Page 28)

© TELENAV 2003-5 PAGE 28 OF 34
Using a Waypoint as an address
If you choose to use a Waypoint as an address, you will be presented with a list of waypoints you have previously
marked and labeled as shown above under View Waypoints. Highlight the one you want, and press OK. At this
point, your phone will contact the TeleNav servers to convert the latitude and longitude of the waypoint to an
approximate street address.
Guidance Instructions
The guidance instruction screens you will see have the following content, but will have different proportions than
those shown below. GPS navigation and Non-GPS directions screens have slightly different content explained
below. When TeleNav is communicating with the TeleNav servers, a network activity indicator replaces the GPS
indicator shown below.
Lawrence Expwy
CA CR-9N
3.4 mi
US 101 N
6.2 mi NW
Direction of
travel
GPS
satellite
indicator
Remaining
distance
Distance to
next turn
Current
street
name
Upcoming
turn type
icon
Upcoming
street
name and
alternate
name
Navigation guidance
If you will be traveling on the same roadway for a mile or more, the Upcoming and Current Street names will be the
name of the street you are on, and the turn type icon will be a vertical arrow. As you approach the turn, the
Upcoming Street name will change, and the icon will portray the actual type of turn you should make. As you
move, the distance to turn and the remaining distance will decrease. Visit the TeleNav website to alter this
behavior as described below under Personalization.
Eventually, you will see the destination arrival screen. This screen will show you how far it is to your destination
and whether it is on the left or right side of the street or road.
For TeleNav to work, the GPS receiver must be tracking four or more satellites. When 3 or less are being tracked,
the satellite indicator will be blank. When four satellites are being tracked, one bar will appear. As more satellites
are tracked, more bars appear. If the indicator is blank, you should more to an area with a clearer view of the sky.
When you arrive at your destination, press MENU. The available options will allow you to go back to the TeleNav
menu. You can also press MENU and select a whole route map.