Ridetech 41232000 - Manual (Page 3)

5. To install the front floor pan
bracket, the kick panel must be
removed.
6. Use the door bar to determine the
location of the floor pan mount. Drill
two 3/8” holes in the kick panel.
9. Using the bracket as a template,
drill four 3/8” holes through the floor
pan. (The middle two do not need to
be drilled).
10. The inner two most holes will
bolt to this bracket using 3/8” x 1 ¼”
bolts, flat washers and Nylok nuts.
11. Using the bracket as a template,
drill four 5/16” holes in the frame rail.
Use four 3/8” x 1” self tapping screws
to fasten the bracket to the frame.
7. Place the reinforcement plate
inside the kick panel and secure the
assembly with two 3/8” x 1 ¼” bolts,
flat washers and lock washers.
8. Remove the door bars.