Ridetech 11306699 - Manual (Page 2)

Installation Instuctions
1. Replace the factory upper
trailing arm with the StrongArms.
5/8” x 3 ¾” bolts and Nylok jam
nuts are supplied to replace the
factory hardware. An aluminum
spacer will be installed on each
side of the Heim end.
Note: Some cars may have two
upper arms. In this case you will
need to order a second upper arm,
part # 11306698
10. Replace the factory panhard
bar with the new one using the new
stud and hardware supplied. The
rubber rod end will be attached to
the axle.
Check air spring clearance
through full suspension travel.
Allowing the air spring to rub will
result in failure and is not a
warrantable situation.