Ridetech 11289102 - Manual (Page 3)

5. Attach the axle bracket, bushing
and bushing bracket to the axle
using the U bolt, 7/16” Nylok nut
and flat washers supplied.
6. The inside edge of the axle
bracket should be 2 3/8” from the
center section. If you are using an
aftermarket axle the brackets
should be 21 7/8” apart, from inside
to inside.
Note: Be sure not to put the bar on
upside down. The back section of
the bar should drop down to allow
differential cover access.
8. Check MuscleBar clearance
through full suspension travel.
Congratulations!!! Your new
MuscleBar installation is now
complete. If you have any further
questions please call our tech
support line. 812-482-2932
7. Attach the sway bar to the
PosiLink using a 10mm Nylok nut
and two 3/8” flat washers.
PDF created with pdfFactory trial version www.pdffactory.com