Ridetech 11379103 - Manual (Page 3)

Rear Sway Bar Installation
1. Park truck on a level surface and secure the front tires with blocks.
2. Raise rear end and place axle on jack stands.
3. Assemble the dog bones and upper frame brackets on the rear bar. NOTE: Lightly
pre-grease all pivot points with supplied grease. Note hardware placement in picture.
Also see attached page.
4. Lift the brake lines to allow the U-bolts to pass under. Place the U-bolt around axle
and in the center of the rear shock brackets. Hang the assembled sway bar onto the
axle placing the U-bolts thru the axle brackets and the bushing brackets. (NOTE: one
extra pair of hands is recommended for this operation.)
Note
hardware
placement.
Lift brake line
to allow U-bolt
to pass under it.
Place
the axle
bracket
in the
center
of the
rear
shock
mount.