Ridetech 11177199 - Manual (Page 7)

7
19. Apply thread sealant to an elbow air fitting and
screw it into the top of the Shockwave.
20. Screw the lower Shock stud into the billet
mount. Bolt the Shockwave to the stud with the
Nyloc nut. There should be one spacer on either
side of the bearing. The top eyelet will bolt to the
cradle using a ½” x 2 ¼” bolt and Nylok jam nut.
21. The 4 ½” spacer can now be removed.
22. The exhaust will have to be rerouted.
23. The factory rear sway bar will not work, but
most aftermarket ones will.
22. Double check to make sure the air spring
cannot rub on anything at any time. This will
cause failure and is not warrantable.