Ridetech 11376799 - Manual (Page 5)

16. Fasten the shock stud to the notch
and then slide shock onto stud.
17. The shock will attach to the lower
bridge using a 1/2” x 2 1/2” bolt and
nyloc.
21. Remove 3 bolts from the axle
cover and attach panhard bar mount
as shown. Use the 5/16” x 2” bolts that
are supplied.
22. Attach the brake line bracket to the
axle cover as shown. Bolt brake lines
to bracket.
23. Slide panhard bar on stud and
secure with nut and washer. The other
end of the panhard bar will attach to
the upper bridge.
18. Bolt in the upper bridge between
the frame rails attaching to the C
notch. Use 1/2” x 1 1/2” bolts supplied.
19. Apply a tread sealant to the air
fitting and tighten to snug in air spring.
Place lower plate onto lower bridge
then air spring and secure with 3/8” x
1” bolt. The air spring will attach to the
upper bridge also using a 3/8” x 1” bolt.
20. The brake flex line will attach to
the hard line with the tab on the upper
bridge