Ridetech 11376799 - Manual (Page 3)

Installation Instructions
1. Raise vehicle to a safe and comfortable working height supported by jack stand. Let the
suspension hang freely.
2. Remove bed mount bolts, gas filler neck, and all electrical wires. Safely lift bed from frame.
3. Remove the leaf springs and shocks while supporting axle.
4. The exhaust will need to be removed from the muffler rearward. The exhaust can either be
rerouted when installation is complete or a turndown may be installed.
5. Hold the C-notch template up to the
frame. It will index off two small holes in
the frame, one in front of the notch and
one behind. Scribe the cutout in the
frame.
6. Drill one 1/2” hole in each of the top
corners of the notch as shown. This will
give a round corner instead of a sharp
corner to reduce stress points and
eliminate the possibility of a fracture.
7. SUPPORT THE REAR PORTION OF
THE FRAME BEFORE CUTTING!
8. Cut the notch out with a sawzall or
plasma cutter. Watch for the fuel tank
and any wires or hoses.
9. Slide notch onto frame and align with
index holes. Drill holes in frame and
fasten with 1/2” x 1-1/2” bolts nylocs and
washers.
10. Place bump stop through the hole in
the center of the notch and fasten with
supplied nyloc and washer.