Ridetech 12186799 - Manual (Page 2)

Installation Instructions
*******Must use RideTech rear shock kit*******
1. Raise the vehicle to a safe and comfortable working height.
2. Support the axle and remove the leaf springs, shock absorbers, factory bump stops and
front leaf spring hanger.
3. The rear leaf spring shackle and hanger may also be removed but is not necessary.
4. The exhaust tail pipe & mounts will also have to be removed from the rear of the muffler
back. A turn down can be installed or a custom tail pipe can be made.
6. Passenger side corner of the
canister must also be trimmed at a
45 degree angle.
5. This tab on the front driver side
of the charcoal canister must be
removed for clearance.