Pypes Performance Exhaust SFM67 - Manual

SFM60S / SFM60V / SFM60VS / SFM67
SFM60S: 2005-10 GT 409 Stainless Axle-back w/ Street Pro Muffler
SFM60V: 2005-10 GT 409 Stainless Axle-back w/ Violator Muffler
SFM60VS: 2005-10 GT 304 Polished Stainless Axle-back w/ Violators
SFM67: 2005-10 V6 409 Stainless Axle-back
Thanks again for purchasing your new stainless steel Pypes Performance
Exhaust 05-10 Ford Mustang Axle-back system. Please be sure to confirm
all the components in the kit were received in your shipment before begin-
ning installation. These kits will include 2 muffler assemblies w/ 4” polished
stainless rolled edge tips and a pair band clamps. V6 owners receive one
passenger side axle-back and one band clamp. If you find any components
missing, please contact our office at 800-421-3890 for replacement. Installa-
tion of these kits will require a few simple tools: jack stands, 13mm & 15mm
wrenches and penetrating oil. For a quicker and tighter installation, air tools
are recommended. Technical assistance is available online at:
www.pypesexhaust.com or 800-421-3890.
Pypes Performance Exhaust
2705 Clemens Road Bldg 105A Hatfield, PA 19440
800-421-3890 (voice) 267-638-3507 (fax)
www.pypesexhaust.com
SFM60S/ SFM60V/ SFM60VS
1. Begin by placing the vehicle on a lift or four jack stands at maximum height. This will aid in an easier installation.
2. Unbolt the factory band clamps (15mm wrench) connecting your factory axle-back to your mid-pipes. Soaking your factory
mounting points with penetrating oil will allow for easier removal. Next, remove the 4 OEM hanger bolts (13 mm wrench) located on
the frame rail. Now, drop the muffler out from under the car and repeat for the other side.
3. It’s time to install your new axle-back system. Begin by installing the two band clamps on to the muffler necks. Place the factory
hangers in the welded wire forms on the axle-backs in the same manner that they were removed. Slide the muffler necks on to the
mid-pipes, and then bolt the hangers on to the frame rails. Once all the hanger bolts are tight make sure the tip is adjusted properly
in the bumper cut-out and now tighten the band clamps. The use of several washers can help center the tips. Be sure to check all
the connection points periodically, as they may come loose.
Note: If you find the new tips are not aligned properly in the bumper cutouts, you may need to adjust your factory mid-pipes by
loosening the two band clamps located where your factory h-pipe meets the mid-pipes. A slight rotation of the mid pipes will allow for
the best fit. Also, the use of several washers in between the hangers and frame rail can improve the tip position.
SFM67
1. You will be following the above directions but only working on the passenger side of your vehicle. The V6 Mustang also has an
extra hanger near the muffler neck which will not be used when installing your new axle-back.
Now it’s time to fire up that muscle car and enjoy your
new Pypes Performance Exhaust.