Overview, Software installation, Software – Nitrous Express Maximizer 3 User Manual
Page 3
1
1
1
.
.
O
O
v
v
e
e
r
r
v
v
i
i
e
e
w
w
The MAXIMIZER-3 NITROUS CONTROLLER combines the functions of a throttle position switch,
two RPM window switches, and a 2 stage progressive driver all into a very compact module. It can
progressively drive two channels, each with a 40 amp load capacity (continuous duty) or as 1 channel
with a 80 amp load capacity .The device supports low-voltage OEM, V10 or 3 cylinder TACH signals
without the need for additional adapters and works with most OEM throttle position sensors including
drive-by-wire vehicles. The MAXIMIZER-3, with its "real curve" ramp, allows you to create a
progressive curve instead of just a linear ramp. The ramp can be Time based, RPM based or Throttle
based. It also features traction controlled progressive nitrous when used with the Davis Technologies
Traction Control module.
2
2
.
.
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
If you have the autorun feature enabled on your cdrom drive, wait for the navigation screen and follow
the instructions to install the software. If the application does not auto-start, go to the cdrom directory
and run “startpgm.exe”
3
3
.
.
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
The following settings do not require that the controller be connected to the PC until you are ready to
UPLOAD. All changes made to the set-up require that you UPLOAD to the controller. (See
Upload/Download section).
NX — rev A