JELD-WEN JII026 Wood Patio Doors with Exterior Trim or Nailing Fin User Manual

Page 4

INSTALLATION INSTRUCTIONS

for Wood Patio Doors with Exterior Trim or Nailing Fin (JII026)

c. Remove the upper end corner of each side piece, and for step-

down landings, remove the lower end corner.

d. Apply the

side pieces of
self-adhesive
flashing.

e. Remove the

corners of the
header piece
and apply.

3. Apply sealant across

flashing/masonry
joints at corners of
masonry opening.

4. Apply diamond

lath to all flashed
surfaces to be
covered by stucco.

END of Buck
Instructions, SKIP to
section 7, “PREPARE
PATIO DOOR.”

Note!

This section covers installations into a buck only. For, stud-framed

wall installations skip to section 6, “PREPARE STUD-FRAMED WALL.”
1. On the exterior,

coat the buck
and surrounding
concrete/masonry
with self-
adhesive flashing
primer. Follow
manufacturer’s
instructions
for application
procedures.

2. Seal the joint

between the buck
and the concrete/
masonry with self-
adhesive flashing as
follows:

a. Cut four pieces

of self-adhesive
flashing for the
sill, sides and
head as shown.

b. Apply the sill

pan piece of
self-adhesive
flashing over
the sill pan as
shown. The
bottom of the sill pan should be sealed by the flashing.

Note!

Do not allow gaps or bubbles beneath the flashing (remove and

replace if necessary).

2. Mark a line across

the front and back
of the sill pan.

3. Apply three 3/8"

beads of sealant
between the lines.

4. Place the sill pan in

the rough opening.
Firmly press the sill
pan into the sealant
with a J-roller.

If installing into

masonry:

1. Cut a piece of self-

adhesive flashing
the length of the
sill.

2. Cut a notch out of

each end and apply
to the sill as shown.

Both installations:

1. Set the sill pan

in the rough
opening, aligning
the front edge (for
continuous slab,) or
folded down edge
(for step down) with the exterior of the rough opening.

INSTALL SILL PAN

PREPARE BUCK

Sealant

Top

= Remove for step down only

1.5"

Rough opening side jamb +3"

Rough opening head/sill +3"

1.5"

Head/Sill piece

Side piece