JELD-WEN JII023 Vinyl Projecting Windows with Integral Nailing Fin User Manual

Page 6

INSTALLATION INSTRUCTIONS

for Vinyl Projecting Windows with Integral Nailing Fin (JII023)

4. Press the

adhesive
section of the
flashing onto
outside section
of sill.

5. Pull release

tape on
remaining
section of the
flashing.

6. Fold the

flashing down
onto the house
wrap.

7. Staple flashing

to the wall and
seal the corner
edges.

Note!

The sill lip is the garden window’s only source of support inside

the rough opening. It is very important that the sill be level and flat.
1. Measure the

length of the
sill and cut
a piece of
flashing the
exact length of
the sill.

2. Measure and

draw a line
1/2" from the
exterior edge
of the sill; this
is where the
flashing will sit.

3. Remove foam

backing and
release tape
under foam
backing.

1/2"

Width of

rough opening

PREPARE SILL FOR GARDEN WINDOW

Release

tape

Seal

corners

3. Inspect window for square, level, and plumb. Test for proper

operation (remove and reinstall if necessary).

Note!

Fastener

heads must be
flush. Do not
dent nailing fin.
Always use pre-
punched holes or
pre-drill with a
3/16" bit.
4. Fasten window

through nailing
fin holes 3"-
7" from the
corners and 8"
apart all the
way around
the window.

3"-7"

INSTALL GARDEN WINDOW

Warning!

To avoid injury, use at least two people to install. Temporarily

support the window until fully installed.
1. Place window

sill onto the
drain mat and
tilt into the
rough opening.
The window
sill must rest
on and be fully
supported
by the rough
opening
framing.

2. Fasten

window with
a galvanized
roofing nail
through the nailing fin between 3"-7" from one lower corner.

3"-7"