JELD-WEN JII031 Aluminum Windows without Nailing Fin User Manual

Page 6

INSTALLATION INSTRUCTIONS

for Aluminum Windows without Nailing Fin (JII031)

Please visit jeld-wen.com for warranty and care

and maintenance information.

Thank you for choosing

(05/14)

©2014 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual property laws. All trademarks, service marks,
logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others. Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.

JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.

1. Create a continuous

air seal on the
interior by filling the
gap between the
rough opening and
the window frame
with low expansion
polyurethane foam
or backer rod and
sealant.

2. On the exterior,

apply backer rod and
sealant between the
window frame and
the rough opening
(not applicable to
flush fin windows).

AFTER INSTALLATION

• Ensure weep holes/channels are clear of debris for proper water

drainage; do not seal weep holes/channels if present.

• Adjust window for best operation.
• Protect recently installed units from damage from plaster, paint, etc.

by covering the unit with plastic.

COMPLETE INSTALLATION

Sealant

joint

Backer

Rod

Gap