ididit Cable Shift Linkage Kit: Ford Column to Ford C-4 Transmission - Manual (Page 5)

12. On the C-4 transmission you
must cut off the original shift
lever on the transmission.
Note: Once you cut the old
shift lever off, there is no
turning back! Remove the
two side cover bolts marked
with X’s. Also remove the
nut and washer from the kick
down lever and then remove
the kick down lever itself.
13. Make sure that the
transmission is in Park.
Install the transmission shift
lever using the nut and bolt
supplied. Now install the kick
down lever with the original
nut and washer as shown
above. Install the cable
bracket and the two bolts as
shown.
14. Take the small nut, two rubber
boots, and one large nut and
washer off the transmission
end of the cable. Insert
the cable into the bracket.
Reinstall the large washer and
nut and two boots. Rotate
the shift lever clockwise to
the Park position. Now you
are going to put the swivel
onto the threaded end of the
cable and turn it until it lines
up with the hole of the shift
lever. Install the cotter pin.
If it needs more travel, loosen
the large nuts and washers and move the cable forward or backward to
gain more travel. Then retighten the large nuts and washers. Install the
small nut and tighten.
4