ididit Cable Shift Linkage Kit: Column to Chrysler 727&904 Transmission - Manual (Page 5)

11: Make sure that the
transmission is in park.
Install the transmission
shift lever using the nut
and bolt supplied. Now
install the kick down lever
with the original nut and
washer as shown above.
12: Take the small nut, two rubber boots and one
large nut and washer off of the transmission
end of the cable. Insert the cable into the
bracket. Reinstall the large washer and nut
and two boots. The cable should be pushed
down in the oval slot. Rotate the shift lever
clockwise to the Park position. Now you are
going to put the swivel onto the threaded end
of the cable and turn it until it lines up with
the hole of the shift lever from the bottom side.
Install the cotter pin on the top side. If it needs
more travel, loosen the large nuts and washers
and move the cable forward or backward to gain more travel. Then
retighten the large nuts and washers. Install small nut and tighten.
4