ididit Cable Shift Linkage Kit: Column to Ford C-4 Transmission - Manual (Page 5)

11. Take the small nut, two rubber boots and one large nut and washer off
the transmission end of the cable. Insert the cable into the bracket.
Reinstall the large washer and nut and two boots. Rotate the shift lever
clockwise to the Park position. Now you are going to put the swivel
onto the threaded end of the cable and turn it until it lines up with the
hole of the shift lever. Install the cotter pin. If it needs more travel
loosen the large nuts and washer and move the cable forward or back-
ward to gain more travel. Then retighten the large nuts and washers.
Install the small nut and tighten.
4