ididit Electrical: Tilt Lever Momentary Switch 510168 - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI • PH: 517-424-0577 • FAX: 517-424-7293 • ididitinc.com
Instruction #: 8000020056 REV 10/10
Tilt Lever Momentary Switch: 510168
The function of the momentary switch button on the turn signal lever or the tilt column lever is to trigger a ground
signal to a momentary switch module designed to set functions based on each ground trigger. This lever can be
used with a wiper or dimmer kit, it can also be used for other items.
1. Thread this lever into the hole on the side of the column taking care to prevent the wire from chafing on the
column.
2. Using a piece of florist wire, fish the wire down through the column to where the wires exit. Then tape the gray
wire to the florist wire and gently pull the wire through the column.
3. Attach the gray wire from the lever to the gray wire on the dimmer/wiper kit per instructions.
Please Note: This lever must be grounded for the switch to work properly. The lever should be grounded
through the column, but if you have a fiberglass car, you must provide a ground to the column for this to work
properly.