ididit Electrical: Turn Signal Lever Momentary Switch 510169 - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI • PH: 517-424-0577 • FAX: 517-424-7293 • ididitinc.com
Instruction #: 8000020055 REV 10/10
Turn Signal Lever Momentary Switch: 510169
The function of the momentary switch button on the turn signal lever or the tilt column lever is to trigger a ground
signal to a momentary switch module designed to set functions based on each ground trigger. This lever can be
used with a wiper or dimmer kit, it can also be used for other items.
1. Install the turn signal lever through the turn signal hole and onto the relief in the turn signal switch. Put the
screw through the eyelet in the black ground wire and install the screw through the lever and onto the switch.
You will notice that the lever has a groove that the eyelet sets down onto. Make sure the eyelet sets into this
groove and tighten the screw as tight as you can without stripping it. You cannot hurt the switch; there is a metal
insert behind the plastic.
2. Route both the tan and gray wires down through the column. If this is an ididit or GM column you will see a ½”
hole down through the column at the 8:00 position. This is a route for the wires. Tip: Use a piece of florist wire
to fish the wire through the column. Once it is through then tape the wires together and pull them through the
column carefully.
3. Attach the black wire to a ground source. Attach the gray wire to the gray wires on the dimmer or wiper kit per
its instructions.