ididit Steering Wheel Adaptor: Grant Tuff Grip Steering Wheel to ididit Adaptor - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Grant Tuff Grip Steering Wheel to an ididit Adaptor
For Part Number’s 2611010010
Instruction #: 8000010007 REV 12/12
Kit includes:
A- 3 Speciality Bolts
B- 3 Nylock Nuts
C- 3 Foam Bumpers
D- 1 Contact Plate
E- 1 Spring
F- 1 Horn Wire
G- 1 Horn Catch
Installation Instructions:
1. Attach the three foam pads to the metal rivet of
the contact plate. (Figure 2)
2. Attach the contact plate onto the steering wheel
with the metal side face down. Install the bolts
and Nylock nuts that are provided and Torque to
11 ft. lbs.
(Figure 3)
3. On the adaptor, there is a hole that is in the 10:30
position. This is where the horn wire will be
installed. Install the spring, wire and connector
into the hole and gently turn it a 1/8 turn to the
right (clockwise).
(Figure 4 & 5)
4. Install the steering wheel with the provided bolts
onto the adaptor. Then feed the horn wire up
through the back of the wheel so the wire can
be attached to the front of the fiber plate on the
terminal provided there.
(Figure 3 A.)
5. Install the metal cap over the fiber disk. This
should snap over the disk when pushing it down.
Next, install the plastic button over the metal cap
by pushing it down. Your installation is now
complete.
(Figure 6)