ididit Universal Steering Column: Old School Straight Horn Kit - Manual (Page 3)

6. Next, slide the brass sleeve with the black delrin end caps onto the
column shaft. (Make sure the upper bearing is positioned above the
sleeve on the shaft). Position the brass sleeve so the horn plunger
keyhole will be centered above it.
7. Position the set screws on the delrin end caps so that the screws
contact the flat side of the shaft (see Figure 1) . Also check to make
sure the screws are offset from the soldered horn wire to ensure
easy tightening (see Figure 2) .
8. Pass the horn wire through the bearing between the inside diameter
of the bearing and the flat of the shaft (see Figure 3) . Then pass
the wiring through the head of the column using the existing hole
(see Figure 4) .
9. Straighten the horn wire on the shaft using the supplied wire ties.
a) Space the wire ties evenly along the shaft.
b) Position the ties so that the wire tie head is on the flat of the
column shaft to prevent scraping noises, etc.
c) Trim off excess wire tie.
Figure 1: Set
screws should
contact the flat
side of shaft.
Flat of
column shaft
Figure 2: Set
screws should
be offset from
horn wire.
Figure 3
Figure 4