Equus 3130 - Scan Tool – OBD2 - Manual (Page 40)

Live Data Mode
RECORDING (CAPTURING) LIVE DATA
38 OBD2
E
1. With the Scan Tool in "Live Data" mode
(see Viewing Live Data on page 35 for
details), press and hold the ENTER/LD
button until the "Mode Selection
Menu" appears.
2. Use the UP and DOWN but-
tons, as necessary, to highlight “Live
Data Menu”, then press the ENTER/LD
button.
■ The "Live Data Menu" displays.
3. Use the UP and DOWN but-
tons, as necessary, to highlight “Record
Live Data”, then press the ENTER/LD
button.
■ The "Record Live Data Menu" dis-
plays.
4. Use the UP and DOWN but-
tons, as necessary, to highlight Record
by DTC trigger, then press the
ENTER/LD button.
5. When the "Record by DTC Trigger" screen displays, select the
desired trigger point as follows:
The Scan Tool is capable of recording approximately 20
frames of Live Data. Record by DTC trigger lets you select
the point in time at which you wish the Scan Tool to begin
recording Live Data. You can set the trigger point to record
the 20 frames of data before an event (when the DTC sets),
after the event, or in the middle (10 frames before and 10
frames after the event.
■ Beginning - records approximately
20 frames of Live Data after the DTC
sets.
■ Middle - records approximately 10
frames of Live Data before and 10
frames after the DTC sets.
■ End - records approximately 20 frames
of Live Data before the DTC sets.
6. Use the UP and DOWN but-
tons, as necessary, to select the desired
trigger point, then press the ENTER/LD
button.