Equus 3130 - Scan Tool – OBD2 - Manual (Page 36)

34 OBD2
E
Using the Scan Tool
I/M READINESS TESTING
4. When a Monitor's Trip Drive Cycle is performed properly, the
Monitor icon on the Scan Tool’s display changes from "flashing" to
"solid,” indicating that the Monitor has run and finished its diagnos-
tic testing.
■ If, after the Monitor has run, the MIL on the vehicle's dash is not
lit, and no stored or pending codes associated with that particu-
lar Monitor are present in the vehicle's computer, the repair was
successful.
■ If, after the Monitor has run, the MIL on the vehicle's dash lights
and/or a DTC associated with that Monitor is present in the vehi-
cle's computer, the repair was unsuccessful. Refer to the vehi-
cle's service manual and recheck repair procedures.