Equus 3110 - CanOBD2 Diagnostic Tool - Manual (Page 8)

About the Code Reader
VEHICLES COVERED / BATTERY REPLACEMENT
6 CAN OBD2
E
On some Asian and European vehicles the DLC is located
behind the “ashtray” (the ashtray must be removed to access
it) or on the far left corner of the dash. If the DLC cannot be
located, consult the vehicle’s service manual for the location.
BATTERY REPLACEMENT
1. Locate the battery cover on the back of the Code Reader.
2. Slide the battery cover off (use your fingers).
3. Replace batteries with three AA-size batteries (for longer life, use
Alkaline-type batteries).
4. Reinstall the battery cover on the back of the Code Reader.
Language Selection After Battery Installation
There are two versions of the Code Reader: English/Spanish and
English/French. The first time the unit is turned on (after the batteries
are installed or replaced), you must select the desired display lan-
guage, as follows:
1. Press the POWER/LINK button to turn the Code Reader “ON.”
■ The Select Language screen displays.
2. Use the UP and DOWN but-
tons, as necessary, to highlight the
desired display language.
3. When the desired display language is
selected, press the ENTER/FF but-
ton to confirm your selection.
■ The selected language will remain in
the Code Reader’s memory as long
as the batteries are not removed. If
the batteries are removed (or go
dead), the language selection will be
lost from the Code Reader’s memory
and must be reset again using steps
1 through 3, above.
■ After the initial language selection is performed, it as well as
other settings can be changed as desired. See ADJUSTMENTS
AND SETTINGS on page 7 for further instructions.