Equus 3110 - CanOBD2 Diagnostic Tool - Manual (Page 11)

About the Code Reader
ADJUSTMENTS AND SETTINGS
CAN OBD2 9
E
Demo Mode
1. Use the UP and DOWN but-
tons, as necessary, to highlight Demo
Mode in the MENU, then press the
ENTER/FF
button.
2. The Code Reader enters the Demo
Mode.
3. Demo Mode demonstrates examples of Generic and Enhanced
(Manufacturer Speciific) Diagnostic Trouble Codes, code definitions,
Freeze Frame data and I/M Readiness status.
■ Use Demo Mode to familiarize yourself with Code Reader oper-
ation, vehicle diagnostic data and/or for demonstration purposes.
4. To exit Demo Mode, turn the Code Reader off by pressing the
POWER/LINK button.
Exiting the MENU Mode
1. Use the UP and DOWN buttons, as necessary, to highlight
Menu Exit in the MENU, then press the ENTER/FF button.
■ The LCD display returns to the DTC screen.
Changes made to Brightness, Language and Unit of
Measure will remain in the Code Reader’s memory as long
as the batteries are not removed. If the batteries are removed
(or go dead), the settings will be lost from the Code Reader’s
memory, and they must be reset again.