Equus 3173 - Import Code Reader - Manual (Page 43)

Toyota/Lexus
CODE RETRIEVAL PROCEDURE
Chapter 5 40
Toyota Code Retrieval Procedures (Cont)
Lexus Code Retrieval Procedures
Tool
Model Years Eng. Req? Perform the following:
Cressida 87-92 2.8, 3.0 Y Codes will continue to cycle as long as
Land 88-94 4.0, 4.5 the ignition is on and the Code Reader
Cruiser is connected.
Paseo 92-95 1.5
Pickup 87-95 2.4, 3.0
(Fl only)
Previa 91-95 2.4 (exc. SC)
Supra 87-95 3.0
T100 93-94 3.0
Tercel 89-94 1.5
4 Runner 87-95 2.4, 3.0
(cont)
MR2 85-89 1.6 Y Procedure: Locate rectangular diag-
91-95 2.0, 2.2 nostic connector (under hood) (T7). Plug
Code Reader into diagnostic connector.
Turn ignition on. Observe “Check
Engine” light for codes.
Codes: If there are no codes stored in
memory, the “Check Engine” light will
blink once every six seconds on 85-88
models, and about two times per second
on 89-95 models. If codes are stored,
codes are displayed using a series of
blinks and pauses. Example: blink-
pause-blink blink blink = code 13 (T9).
If more than one code is stored, codes
are separated by a 2.5 second pause.
When all codes have been displayed,
there is a 4.5 second pause, then the
codes are repeated. Codes will continue
to cycle as long as the ignition is on and
the Code Reader is connected.
Tool
Model Years Eng. Req? Perform the following:
ES350 90-91 2.5 Y Procedure: Locate rectangular diag-
ES300 92-93 3.0 nostic connector (under hood) (T7). Plug
GS300 93-95 3.0 Code Reader into diagnostic connector.
LS400 90-94 4.0 Turn ignition on. Observe “Check
SC300 92-95 3.0 Engine” light for codes.
SC400 92-95 4.0