Equus 3173 - Import Code Reader - Manual (Page 23)

Honda/Acura
ERASING CODES
Chapter 3 20
ERASING CODES
• Always observe safety precautions whenever working on a
vehicle.
• Remove Code Reader from vehicle’s test connector before
erasing codes.
• Erase codes only when all repairs have been completed.
Refer to “Honda Erasing Procedures” or “Acura Erasing
Procedures” for specific instructions for your year, make
and model.
• After erasing codes, verify that repairs were successfully
completed. Start the engine and warm to normal
operating temperature. After normal operating
temperature is reached, turn off the ignition and repeat
the code retrieval procedure for your vehicle. If no codes
are retrieved, the repair(s) was successful.
NOTE: Removing fuses or battery cables may clear the memory
on the radio, clock, etc., or may enable the “Theftlock” feature
on the radio.
Honda Erasing Procedures
Acura Erasing Procedures
Model Years Procedure
Accord 84-85 Remove fuse No. 10 for 10 seconds
87-89 Remove fuse No. 11 for 10 seconds
90-93 Remove fuse No. 24 for 10 seconds
Civic / 94 Remove “Radio” fuse for 10 seconds
CRX
87-91 Remove fuse No. 30 for 10 seconds
Del Sol 92-95 Remove fuse No. 32 for 10 seconds
Odyssey 93-95 Remove “Radio” fuse for 10 seconds
Prelude 90 Remove “Radio” fuse for 10 seconds
89-91 Remove fuse No. 35 for 10 seconds
92-95 Remove fuse No. 43 for 10 seconds
Model Years Procedure
Integra 86-91 Remove “Hazard” fuse for 10 seconds
92-95 Remove “Back Up” fuse for 10 seconds
Legend 90 Remove “Alternator Sense” fuse for 10 seconds
91-95 Remove fuse No. 15 for 10 seconds
NSX 91-95 Remove “Clock” fuse for 10 seconds
Vigor 92-94 Remove “Back Up” fuse for 10 seconds