EOTech CNVD-T2 Clip-On Night Vision Device - Thermal 2 - Manual (Page 49)

2-27
2.25 VIEWING LIVE IMAGERY
Viewing live thermal imagery from the CNVD-T2 on an
external monitor is accomplished as follows:
1. Remove the video jack plug (captive to the CNVD-T2)
from the video jack.
2. Plug the Image Adapter Cable into the CNVD-T2 by
aligning the white dot on the cable plug with the white dot
on the video jack. Push the cable plug into the video jack
until it locks into place.
3. Attach the BNC connector to an external monitor or
television.
4. Follow the CNVD-T2 startup procedures contained in
section 2.11 and ensure RS170 video format is selected
from the Main Menu as described in section 2.21.
5. Follow instructions provided by the manufacturer of the
monitor or television for viewing video from an external
device.
CAUTION
When the cable plug is inserted into the video
jack, it automatically locks in place. To remove it,
pull straight back on the cable plug. Do not
remove the cable plug by pulling on the cable
itself.