EOTech CNVD-T2 Clip-On Night Vision Device - Thermal 2 - Manual (Page 36)

2-14
SECTION III
SYSTEM MENUS
2.13 GENERAL
With the CNVD-T2 turned on, access the Main Menu by
pressing the MENU / ZOOM button. The Main Menu will
appear in the eyepiece display as shown below.
Figure 2-7. Main Menu.
Menu items are selected (underlined) by scrolling with the
UP / DOWN buttons. Where available, sub-menus are
accessed by pressing the LEFT / RIGHT buttons. Activation
of the selected menu item is accomplished by again pressing
the MENU / ZOOM button.
If there is no button activity within approximately 10 seconds,
the Main Menu will disappear and the CNVD-T2 will revert to
normal viewing mode.
Once activated, menu options will remain at the applied
setting (even if the CNVD-T2 is turned off) until reset by the
operator.
ZOOM 1X
WHOT
CAL
RETINT
RET
PIC
REV
RS170
EXIT