EOTech CNVD-T2 Clip-On Night Vision Device - Thermal 2 - Manual (Page 29)

2-7
SECTION II
OPERATING INSTRUCTIONS
2.5 POWER
Power On
Pressing the POWER button will turn the unit on. The
CNVD-T2 will power up with the same settings selected as
when the system was last turned off.
Standby Mode
NOTE
In Standby Mode, the CNVD-T2 will continue to
draw power that will eventually drain the batteries.
Turn off the unit if it is not expected to be used.
With the system powered on, the CNVD-T2 can be placed in
a Standby Mode for purposes of light discipline by pressing
and holding the MENU / ZOOM button for about 3 seconds.
Pressing any of the LEFT / RIGHT / UP / DOWN buttons will
reactivate the unit. Upon “waking” from Standby Mode, the
unit will retain all settings entered by the operator prior to
being placed in standby.
Power Down
To turn off, press and hold the POWER button for
approximately 3 seconds as the messages OFF? then OFF!
appear sequentially in the eyepiece display. Release the
POWER button when the eyepiece display turns dark.