EOTech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUMINATOR AIMING LIGHT - Manual (Page 39)

2-17
2.8 MODE SELECTION
WARNING
The Class 3R lasers (low power) described in
Table 2-8 may be used in force-on-force training
only if opposing forces are beyond the NOHD
values shown in Table i-1.
WARNING
The Class 3B lasers (high power) described in
Table 2-8 shall NOT be used in force-on-force
training.
WARNING
To prevent inadvertent activation of the lasers, the
ATPIAL should be in the O (OFF) position when
not in use.
Modes of operation are accessed by turning the Mode
Selector to the desired position. The P (PROGRAM)
position allows for setting the desired IR Illuminator pulse
rate (see section 2.11, IR Illuminator Pulse Rate).
Figure 2-10. Mode Selector.
MODE
SELECTOR