Table 1-3. list of features and controls – EOTech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUMINATOR AIMING LIGHT User Manual
Page 21
1-9
1.9 FEATURES AND CONTROLS (Continued)
Table 1-3. List of Features and Controls.
Key
Control/
Indicator
Function
1 Aim Neutral
Density / Opaque
Lens Cap
When placed over the Aim Lasers, reduces
scatter from the IR Aim Laser, and blocks
emission of the Visible Aim Laser.
2 Safety Screw
(shown in lockout
position)
When installed in the lockout position,
prevents the Mode Selector from being
turned to the high power laser settings (i.e.,
AH, IH, DH). Removal of the safety screw
allows for access to all modes of operation.
3 Mode Selector
Allows the user to select the desired mode
of operation for the ATPIAL.
4 Illuminator
Adjusters
Used to bring the illumination beam into
azimuth and elevation alignment with the
barrel of the weapon.
5 Illuminator
Diffuser Lens Cap
When installed over the IR Illuminator,
spreads the laser energy, allowing for
illumination of a wider area. This is useful
for illuminating a small room and is most
effective when used with the Focus Ring
adjusted to the widest beam (flood) setting.
6 Infrared
Illuminator /
Focus Ring
Used with night vision devices to provide
IR illumination of the intended target area.
The Focus Ring is rotated to vary the
illumination beam spread from flood to
spot, based on the range and size of the
area to be illuminated.
7 Infrared Aim
Laser
Used with night vision devices to provide a
precision aim point or to mark targets.