Clinton Electronics CE-PTZ-KEY User Manual

Page 22

TOUR

A Tour is an automated cruising through selected preset positions with individual

speed settings and dwell times. This PTZ supports up to 4 tours with 24 positions

each. *NOTE: Before a tour can be properly set up, you must first define your

preset points you wish to include in the tour (see page 16 “Presets”).

A tour sequence will repeat until interrupted by a movement of the joystick

after it reaches a preset point, or until another command is entered (ie.

[SHOT]95[ENTER] to enter menu).

[TOUR NUMBER]: Current tour number

[EDIT TOUR]: Edit the current selected tour as defined in [TOUR NUMBER]

Tour Editing:

PO: The preset position being included in the tour. If there is no preset

position stored, please exit, and define presets before continuing.

S: The speed in which the PTZ moves to this preset. The value is between

1(slow)-8(fast).

TM: The dwell time before the PTZ moves to the next point. Given in

seconds. (Up to 60 sec.)

[RUN TOUR]: This will run the current tour defined in [TOUR NUMBER]

[CLEAR TOUR]: This will erase the current tour defined in [TOUR NUMBER]

[BACK]: Move to previous screen (doing so will save your changes to tour)

[EXIT]: Exit the OSD (doing so will save your changes to tour)

ZONES

The zone function allows user to define a perimeter with a name tag. The

perimeter is defined by setting a Left, and Right end of a desired area. When the

camera enters this area, the name will be displayed on the screen, which provides

better orientation in surveillance applications. Up to 8 zones are supported. Make

sure “Zone Label” is set to “ON” in Display Setup; see pg12.

[ZONE NUMBER]: Current zone number

[SET LEFT LIMIT]: Define the left point of the zone

[SET RIGHT LIMIT]: Define the right point of the zone

[CLEAR ZONE]: This will erase the current zone defined in [ZONE NUMBER]

[EDIT ZONE LABEL]: Assign a name to the current zone defined in [ZONE NUMBER]

[BACK]: Move to previous screen (doing so will save your changes to zones)

[EXIT]: Exit the OSD (doing so will save your changes to zones)

ZONES

- - - - - - - - - - - - - - - - - -

ZONE NUMBER 001

SET LEFT LIMIT -->

SET RIGHT LIMIT -->

CLEAR ZONE

EDIT ZONE LABEL -->

BACK

EXIT

TOUR

- - - - - - - - - - - - - - - - - -

TOUR NUMBER 001

EDIT TOUR -->

RUN TOUR

CLEAR TOUR

BACK

EXIT

EDIT TOUR

PO-S-TM PO-S-TM PO-S-TM

00-0-00 00-0-00 00-0-00

BACK

EXIT