Clinton Electronics CE-ACW - Manual

Pendant Mount Cap Installation Guide
CE-ACW (White) & CE-ACB (Black)
Included Items:
• Pendant Cap x 1
• Mounting Screws x 3
• Conduit Screw Connector x 1
• Instructions x 1
Required Items:
• ¾”Conduit Pipe x 1
• Philips Head Screwdriver x 1
• Clinton Dome Camera x 1
Installing the Pendant Mount Cap
1. Install the Camera Mounting Plate.
Use the 3 supplied screws to install the camera mounting
plate to the pendant cap as shown below.
2. Install Pendant Mount onto location.
Screw the pendant mount cap onto a suitable conduit
pipe that has ¾” NPT threads or use the included
conduit screw connector and tighten the top screw to
secure the pendant cap to the conduit pipe.
3. Connect the Cables
Feed the power and video cables through the pendant
mount cap and connect the power and video cables.
4. Secure the Camera to Pendant Cap
Secure the camera to the pendant cap by matching up the
three mounting posts on the camera mounting plate to
the base of the camera and turn the camera clockwise to
lock into place.
5. Adjust Camera Position and Test
Remove the dome cover and adjust the camera to the
desired position and test. See camera instruction manual
for detailed camera adjustment and settings.
6. Replace the Dome Cover.
Replace the dome cover by slightly turning the dome
clockwise until it locks into place.
v.04.08.09
CLINTON Electronics
6701 Clinton Road
Loves Park, IL 61111 1.800.447.3306 Sales
1.800.549.6396 Support
1.800.633.8712 Fax
www.clintonelectronics.com
Conduit Screw Connector
¾” Conduit Pipe
Pendant Cap
Camera Mounting Plate
Mounting Screws
Camera
Dome Cover