ADC AD-200 - Manual (Page 61)

57
a) Thermal Magnetic Starter (TMS) Replacement
(1) Discontinue electrical power to the dryer.
(2) Mark L1, L2, L3, and T1, T2, T3 on the wires to the TMS for correct replacement.
(3) Set the amp rating on the TMS according to the manufacturer’s electrical schematic on the
new thermal magnetic starter.
(4) To remove the TMS, pull the tab on the bottom and lift upward.
(5) To install new TMS, reverse above procedure (Step #4 thru Step #1).