AMX VTM-D15/A User Manual
Page 37
Configuration and Setup
33
VTM-D15/A 15" MultiMedia Touch Panel Systems
14. Once in the calibration mode, press the middle of the on-panel cross-hairs as they appear. After
the last cross-hair has been depressed and the coordinates points have been set, a dialog
displays the panel coordinate values.
15. Press the screen to exit from the calibration session and return to the panel display.
16. Select Connect > Disconnect to exit from telnet session and close the NetLinx Studio Program.
Send_Command,
Example:
Send_Command 130,"’calibrate’"
Sets up the panel to begin the calibration process. Touch the cross-hairs that appear on the panel to
complete the calibration process.
PRGM EX. 15