American Fibertek Commander C10e-PoE/C10p-PoE - Manual (Page 66)

66
Probe Setup: P-TA/ P-TAH
P-TA and P-TAH are intelligent probes. The parameters applied to a probe via operator
programming will remain even if the probe is unplugged. If connected to another input ( in cases
where a USB hub is used) on the same Commander or another input on a different Commander,
upon power up the probe’s programming will automatically be read from Commander.
Commander will automatically sense which type of probe is connected. If a P-TA probe is
connected Commander will not display any programming for Humidity functions.
Commander can use either of two different types of probes. P-TA is used for sensing
Temperature and Airflow, P-TAH is used for sensing Temperature, Airflow and Humidity. Both
are intelligent and provide communication on their status with Commander.
Note: If you physically add or remove a probe while in the probe set up mode you must perform a
browser refresh to apply the change.
P-TAH: Temperature/Airflow /Humidity Probe setup
P-TA: Temperature/Airflow Probe setup
When a Temperature/Airflow only probe is selected Humidity setups will not appear. The probe
type is automatically read from the probe. When the probe is selected, its type, either P-TA, P-
TAH or P-VFP will automatically appear.