beautypg.com

American Fibertek N-TAH User Manual

Page 40

background image

40

Reboot

The Reboot screen allows the user to perform a hardware reset of the N-TAH. This will
not affect the state of the stored configuration files, but will cause all N-TAH systems to
reset as if a power interruption had occurred. A single button, “Click here to reboot”, is
provided to restart the system.

The N-TAH takes approximately 10 seconds to reboot and return to full function after this
function is used. When the N-TAH is being reset, the aux contact outputs turn OFF until
the reset cycle is completed, at which time it will behave as configured on the ‘Aux
Setup’ page. Any messages to change aux outputs from other devices on the network
will be ignored while the device is rebooting. Alarm conditions on the alarm input
terminals will also be ignored while the device is rebooting.