American Fibertek N-TAH - Manual (Page 35)

35
Probe Setup
The Probe Setup screen will display all current environmental readings for the N-TAH,
and configuration data for actions to be taken when a reading is outside warning or
alarm levels.
A button is provided to set a reference airflow point. When this button is pressed the
attached probe will take the current airflow reading as a 100% reference level. All
following airflow readings will be a percentage of the reference airflow level.
The TCP Message IP field is used to set a target network address and port which TCP
messages indicating the status of each monitored environmental data value will be sent
to on change and optionally at periodic intervals.