AirSep MN152-1 - Manual (Page 16)

12
Symbols
Symbols are frequently used on equipment in preference to words with the
intention of lessening any possibility of misunderstanding caused by language
differences. Symbols can also permit easier comprehension of a concept within a
restricted space.
The following table is a list of symbols and definitions that may be used with
AirSep’s SureFlow. These symbols are referenced from the appropriate
International Electro-technical Commission (IEC) standards.
Symbol Description Symbol Description
Warning – Describes a hazard or
unsafe practice that if not avoided
can result in severe bodily injury,
death or property damage
No smoking
Caution – Describes a hazard or
unsafe practice that if not avoided
can result in minor bodily injury or
property damage
Complies with the 93/42/EEC
directive drawn up by the
approved organization No. 0459
Note – Provides information
important enough to emphasize
or repeat
Use no oil or grease
Do not disassemble
Consult instructions for use
Do not expose to open flames
:WEEE Directive
AirSep Corporation is ISO 9001:2008 and ISO 13485:2003 w/ CMDCAS certified.
European Representative:
Gavin Ayling
9 Bungham Lane
Penkridge Stafford
Staffordshire ST19 5NH England
E-mail:
[email protected]