AirSep MN078-1 F User Manual
Page 35
MN078-1 Rev F
8/12
29
[Read the Important Safety Rules section before operating this equipment.]
Cleaning the Nebulizer
1.
After each treatment, separate the nebulizer and the ³T´ piece or mouthpiece assembly.
2.
Remove or unscrew the nebulizer cup, and rinse each component thoroughly in warm
water.
3.
Once a day, clean all nebulizer parts (excluding air supply tubing) with a mild detergent
or soap solution in warm water. Rinse thoroughly, and soak all parts in a solution of
Figure 8
one (1) part white vinegar and three (3) parts water for 30 minutes to disinfect.
4.
Rinse thoroughly in warm water to remove the disinfectant solution.
5.
Place all nebulizer parts on a paper towel or soft absorbent material to air dry. DO NOT
WIPE DRY.
6.
When dry, store the nebulizer parts in a clean container or plastic bag.
7.
Repeat the above procedure after each treatment/patient use.
Federal (USA) law restricts this device to sale or rental by order of a physician or other licensed health care
provider.
Perform steps 1 and 2 below after each treatment to prevent medication from collecting and hardening
inside the nebulizer parts.