GE 45613 GE Z-Wave 3-Way Dimmer Kit with flying leads - Manual (Page 18)

ADVANCED OPERATION
The following Advanced Operation parameters require that you
have an advanced controller like the 45601 Advanced remote.
Advanced remotes from other manufacturers may also be able
to change these settings; however, basic remotes do not have
this capability.
All On/All Off
Depending upon your primary controller, the 45607 dimmer
switch can be set to respond to
ALL ON and ALL OFF
commands in up to four different ways. Some controllers may
not be able to change the response from its default setting.
Please refer to your controller’s instructions for information on
whether or not it supports the configuration function and if so,
how to change this setting.
The four possible responses are:
It will respond to ALL ON and the ALL OFF command (default).
It will not respond to ALL ON or ALL OFF commands.
It will respond to the ALL OFF command but will not respond to
the ALL ON command.
It will respond to the ALL ON command but will not respond to
the ALL OFF command.
LED Light
When shipped from the factory, the LED on the 45607 is set to
turn
ON when the connected light is turned OFF. This allows the
LED to indicate the switch’s location in a dark room. To make
the LED turn ON when the light is turned ON, change parameter
3’s value to “1”.
1.
2.
3.
4.