GE 45613 GE Z-Wave 3-Way Dimmer Kit with flying leads - Manual (Page 14)

SHOCK HAZARD!
Turn OFF the power to the branch circuit at the circuit
breaker in your electrical service panel. Ensure power
is OFF before you install this device. All wiring connections
must be made with the POWER OFF to avoid personal
injury and/or damage to the switch.
WARNING
Shut off power to the circuit at fuse box or circuit breaker.
Remove wall plate.
!Warning: Verify power is OFF to switch
before continuing.
Remove the switch mounting screws.
Carefully remove the switch from the switch box. DO NOT
disconnect the wires.
Identify the wiring in the box and decide if this will be the
location for the Auxiliary Switch or the Dimmer Switch.
Mark the wiring so it can be identified properly later.
Disconnect the wiring and remove the switch.
Install either the Auxiliary or Dimmer Switch as shown in the
wiring diagram.
Insert the new switch into the switch box being careful not to
pinch or crush wires.
Repeat Steps 2 through 9 for the second switch.
Reapply power to the circuit at fuse box or circuit breaker and
test the system.
Observe Important Wiring Information
Always follow the recommended wire strip lengths and wiring
combinations when making wiring connections. Important:
The wire connectors included with this dimmer are intended to
only be used with copper wire. Consult a qualified electrician
if you have aluminum wiring.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.