GE 45613 GE Z-Wave 3-Way Dimmer Kit with flying leads - Manual (Page 17)

must still tap (press & release) the bottom of the rocker to
turn the power OFF.
- When OFF, pressing and holding the bottom of the rocker will
cause the lighting to go to the minimum dim level.
Program your light Switch (The model 45607 primary switch
must be used to include or exclude the dimmer switch from
the Z-Wave home control network.)
- Refer to the instructions for your primary controller to access
the network setup function and include or exclude devices.
- When prompted by your primary controller, tap the top or
bottom of the rocker.
- The primary controller should indicate that the action
was successful. If the controller indicates the action was
unsuccessful, please repeat the procedure.
- Once the dimmer switch is part of the network, the same
basic procedure is used to add the dimmer switch to groups
& scenes or change advanced functions. Refer to the
primary controller’s instructions for details.
Please Note: After a power failure, the 45607 dimmer switch
returns to its last used On/Off/Dim state.
LED Indicator – Primary Switch Only
- The LED will be lit when the connected lighting is
OFF.
- This is the factory default setting and can be changed if your
primary controller supports the node configuration function
(see Advanced Operation below).