Acer Altos R720 Series - Manual (Page 59)

49
4 Pull out the lever and slide the carrier from the chassis (B).
5 Place the HDD carrier on a clean, static-free work surface.
6 If you are replacing a hard disk, remove the four screws that secure
the hard disk to the HDD carrier, then remove the disk from the
HDD carrier.
Keep the screws for later HDD installation.
To install a HDD:
Note: To puchase a HDD carrier, contact your local Acer
representative.
1 Perform steps 1 to 4 listed on the “To remove a HDD” section on
page 48.
2 Remove the four screws that secure the air baffle to the HDD
carrier (A).
3 Remove the air baffle from the HDD carrier (B).
4 Save the air baffle and screws for later use.
5 Set any jumpers and/or switches on the drive according to the
drive manufacturer’s instructions.